Sequential Injection, installation and setup #1

Hey,

I just finished installing and setting up my seq inj kit.

Let me show you what is it about.

I'm talking about DIYPNP, other MS ECUs already feature seq inj or they can be upgraded in a similar way - check specific instruction for you specific ECU.

The kit:
Kit

Installation instruction:
Instructions

You need to solder the kit male header to the location pointed in the pic:

After Installation:

I run my MS without seq inj for sometime (if  I knew about it the first place I would have installed it from day one...)

Anyway, the default inj installation is batch (running two injectors at the same time), so two injectors were connected to one driver, as follow:

(from 96-97 instructions)

 You can see that INJ1 shoot 4U and 4W and INJ2 shoot 4V and 4X.

The seq inj kit will give us 2 extra INJ drivers (4 total) INJ3,INJ4.

Now !

Which INJ to which  pin ? (4U,4W,4V,4X)

I had to contact support for that - I think it should be a part of the instruction...

The instruction does say :

Main board INJ1: Cylinder 1

Main board INJ2: Cylinder 3

Expansion board INJ3: Cylinder 4

Expansion board INJ4: Cylinder 2

But it does not say nowhere (I looked...) which pin represent which cylinder...

And the answer is (for 96-97 Miata):

Output "INJ1" - 4U - Cylinder 1 Injector

Output "INJ2" - 4W - Cylinder 3 Injector

Output "INJ3" - 4X - Cylinder 4 Injector

Output "INJ4" - 4V - Cylinder 2 Injector

96-97 Diagram - Page 9

My DIYPNP:

The black wire on the left is just passing through the hole on the PCB, on its way to 4V.