Sequential injection means firing each injector separately.
MS default is batch fire, meaning two injector fire at the same time.
Miata (94 and above) run sequential from factory, each injector wire goes all the way to the ECU separately.
So, if your Miata is 94 and above you should start off with sequential injection from the start.
In order to enable sequential injection, you need to add a little module to your MS (DIYPNP only) that will add two additional drivers for the injectors.
The module:
Sequential injection gives you: better efficiency, injection timing, idle smoother, idle smoother with larger injectors, better enrichment, better throttle response.
Do it ! it's good for you !
Unfortunately, the sequential injection compared semi sequential injection has the only fault the crancking is slightly slower , would be the top have the opportunity to have in crancking a SEMI and once the engine has started to move sequentially.
ReplyDeleteI used to run batch before...
ReplyDeletei don't understand
Deletei understand now,but this function on my MS2 not implemented
DeleteWhat function ? batch ?
Deletebatch fire during cranking is possible only on MS3
ReplyDelete